The included smaller picking device, a wire to thread the leader to the jig head loop, and a line cutter make it simple and fast to tie the "Triple Eight Knot" and the "3.5 Knot".
SPECIFICATIONS:
Size: 106 × 23 × 15 mm
Weight: 19 g
Accessory: Preliminary JIG EYE Line Picker x 1 and dedicated driver x 1
MADE IN JAPAN
Triple 8 Knot and 3.5 Knot
● Triple Eight Knot
1) Close the tip of the pickers and pass the pickers through a ring of approximately 1 cm made by overlapping the line and leader line.
2) Open the tip in the ring and make three turns.
3) After that, pinch the line and the leader line to pass through the ring.
4) Tighten the lines slowly, further tighten the line and the leader line, and cut the redundant lines.
(When tightening, wet the line with saliva)
● 3.5 Knot
1) Pass the tip of the pickers through a ring made by overlapping the line and leader line.
2) Pinch and pull out the two lines. Repeat step 2) three times.
(Easier if the overlapping part re-grabbed each time)
3) Extract only the line once more.
4) Tighten the lines slowly, further tighten the line and the leader line, and cut the redundant lines.
(When tightening, wet the line with saliva)
