Hapyson
Hapyson Line Twister YH-716P
AUD $84.50
or make 4 interest-free payments of
$21.13 AUD
fortnightly with
More info
Line Twister
| YH-716P | Operated with Alkaline battery LR03(AAA) x 2pcs Batteries sold separately |
- Can twist the line around the leader easily and quickly.
- Can make stable and strong MID knot with less variation of PE line twisting.
- As it's designed compact size, can put it in a pocket for carrying and use conveniently at fishing ground.
- [Battery Life］ Approx. 500times with Alkaline batteries
- [Compatible Line］ PE Line 0.6号(6lb)～3号(30lb)
- Leader 1.5号(6lb)～12号(40lb)
- [Dimensions］Approx. 65mm x 115mm x 28mm
- [Weight］Approx. 115g included batteries
 (1) Insert the line into the right side of the orange divider on the top insert point. Keep the line about 4 inches out of the twister.
|
 (2) Insert the leader into the left side of orange divider on the top insert point. Keep the leader about 2 inches out of the twister. Insert the leader into the bottom insert point. Make sure that the line and the leader are inserted into the proper insert points and the leader is stretched tightly.
|
 (3) Pull the line lightly in the opposite direction of the twister and turn on the switch.
|
 (4) Twist the line down about 15 - 20 times.
|
 (5) After 15 - 20 times, point the line upwards, twist the line another 15 - 20 times and release the switch coming to the first position.
|
 (6) Remove the leader from the bottom insert point and pull down about a half an inch, set the leader back into the bottom insert point.
|
 (7) Remove the PE line from the top insert point and insert the rod side of the PE line into the top insert point.
|
 (8) Hold the line down with your thumb and tie the line and leader together with a half hitch knot by hand. Repeat the same action about 5 - 7 times.
|
 (9) Remove the line and the leader from the insert points. Pull the line and the leader strongly on both sides to tighten the knot.
|
 (10) To complete MID knot, tie the line tip and the rod side of line together with a half hitch knot 4 to 5 times and lastly an end knot. The finish process is to cut any excess from the line and the leader.
|
 (11) The MID knot is completed state.
|
 |
＜Knot Strength and Advantage by Line Twister＞ ※The knotting process after twisting the line around the leader isn't motorized. It's required knotting by hand. ※Batteries almost consumed may not work at low-speed mode of YH-717P. |
